| |
Subject |
Author |
Date Posted |
Forum
|
 |
RE: RV park in Las Vegas
Another vote for Oasis, off Blue Diamond Rd.
|
gkainz
|
11/10/23 09:03am |
RV Parks, Campgrounds and Attractions
|
|
RE: 2019 Ram 3500 - dash display configuration?
""On the new dashboards, how do YOU have your dashboard display configured to show your most important settings/gauges?""
Your question is deceiving as you show a pic of an aftermarket display. Taken literally the question is about the "DASHBOARD" meaning on the truck IMHO but you show something different.
Ok, that's an interesting twist I didn't think of! I didn't intend to deceive. The thought process was "This is what I had (the Edge gauge) and what parameters I used to watch. Now I have a new RAM display and it's a blank slate."
Original post basically said "Here's what I had - how do you have your dashboard set up?" ... I guess I don't see the confusion.
Hey Ram drivers - I just moved up from my 2007 Dodge Ram 2500 5.9 CTD where I have an Edge CTS display to show Boost, EGT, ECT, IAT for towing, to a 2019 Ram 3500 6.7 CTD.
picture of the Edge display was here ...
On the new dashboards, how do you have your dashboard display configured to show your most important settings/gauges?
Thanks!
Greg
|
gkainz
|
06/21/23 04:21pm |
Tow Vehicles
|
|
RE: 2019 Ram 3500 - dash display configuration?
I can't believe how this normally helpful forum was so off the mark on this topic?
My original question was "On the new dashboards, how do YOU have your dashboard display configured to show your most important settings/gauges?"
I didn't ask how to configure, how to operate, how to navigate the screen setup ... I simply asked for some examples of YOUR favorite setup!
In the aviation world, setting up a NAV GPS, there's day long arguments about NORTH UP vs TRACK UP, but I don't think I've seen one of those discussions immediately dive to the bottom of the pool with "Hey, if you can't figure out how to set your GPS to Track Up, I'm not going to show you my setup."
|
gkainz
|
06/21/23 06:35am |
Tow Vehicles
|
|
RE: 2019 Ram 3500 - dash display configuration?
Why? Because I'm also a pilot, and instrument scans is just part of normal operation! :)
@rhagfo - agreed! There's tons of info to be displayed - I was looking for tips on what people find helpful to display and common setups.
|
gkainz
|
06/15/23 02:28pm |
Tow Vehicles
|
|
2019 Ram 3500 - dash display configuration?
Hey Ram drivers - I just moved up from my 2007 Dodge Ram 2500 5.9 CTD where I have an Edge CTS display to show Boost, EGT, ECT, IAT for towing, to a 2019 Ram 3500 6.7 CTD.
https://i.imgur.com/MtFurhRl.jpg
On the new dashboards, how do you have your dashboard display configured to show your most important settings/gauges?
Thanks!
Greg
|
gkainz
|
06/14/23 08:28am |
Tow Vehicles
|
|
RE: Awning misaligned when rolled up?
Well, that was easy! Just numerous trips up and down the ladder, from the awning material retaining screw (at the front of the awning) to the awning control switch (at the rear of the trailer) as I adjusted the material.
I rolled the awning out a few inches and removed the screw that retains the awning material in the slide strip. As soon as I removed the screw, the material slid back a little - I assume from the misalignment of the roller/power head. Went to the back of the awning and gently tugged the material back and it easily moved from there as well. I could nudge it fore and aft and feel the roller somewhat settle into equilibrium - feeling centered.
Went inside and extended and retracted a few times, and repeated the adjustment until both arms fully seated over the inner mount arms. Apparently the material has shrunk, since the arms still rub a bit, but it's good for now.
Also time to replace the material ... so on to that project.
|
gkainz
|
05/08/23 04:58pm |
Tech Issues
|
|
RE: Awning misaligned when rolled up?
You should be able to move the canvas fore/aft on either canvas end after any retaining screws are removed and tension releaved. It's also possible that the 2 canvas ends are not parallel.
Thanks. Will give this a try later today.
|
gkainz
|
05/08/23 07:13am |
Tech Issues
|
|
RE: Awning misaligned when rolled up?
I should have mentioned that I've owned this since new, and it's worked properly until recently.
|
gkainz
|
05/08/23 07:12am |
Tech Issues
|
|
RE: Awning misaligned when rolled up?
pics - not sure if they show the mis-alignment
https://i.imgur.com/oZ3BRSCl.jpg "border=0"
https://i.imgur.com/m3zZPvb.pngClick For Full-Size Image.
https://i.imgur.com/ko2kArQl.jpg "border=0"
https://i.imgur.com/m3zZPvb.pngClick For Full-Size Image.
https://i.imgur.com/iab5i6rl.jpg "border=0"
https://i.imgur.com/m3zZPvb.pngClick For Full-Size Image.
https://i.imgur.com/StuTSISl.jpg "border=0"
https://i.imgur.com/m3zZPvb.pngClick For Full-Size Image.
|
gkainz
|
05/08/23 07:11am |
Tech Issues
|
|
Awning misaligned when rolled up?
I have a 2010 5th wheel that I noticed the awning arms don't align and completely roll closed when I opened it for cleaning this weekend. Both front and back arms mis-align about 1/2" towards the front as they try to close the last little bit, and the outer arm hangs up on the inner bracket.
I tried pushing towards the rear when rolling it up, but can't make it move enough to align and completely close. Is the material moveable easily on the roller, or on the track that attaches to the sidewall?
Other thoughts on re-aligning the roller and arms?
|
gkainz
|
05/08/23 06:33am |
Tech Issues
|
